mirror of
https://github.com/hsoft/collapseos.git
synced 2024-11-08 13:28:05 +11:00
59 lines
2.2 KiB
Plaintext
59 lines
2.2 KiB
Plaintext
# Working with AVR microcontrollers
|
|
|
|
# Assembling AVR binaries
|
|
|
|
TODO
|
|
|
|
# Programming AVR chips
|
|
|
|
To program AVR chips, you need a device that provides the SPI
|
|
protocol. The device built in the rc2014/sdcard recipe fits the
|
|
bill. Make sure you can override the SPI clock because the sys-
|
|
tem clock will be too fast for most AVR chips, which are usually
|
|
running at 1MHz. Because the SPI clock needs to be a 4th of
|
|
that, a safe frequency for SPI communication would be 250kHz.
|
|
|
|
The AVR programmer device is really simple: Wire SPI connections
|
|
to proper AVR pins as described in the MCU's datasheet. Note
|
|
that this device will be the same as the one you'll use for any
|
|
modern SPI-based AVR programmer, with RESET replacing SS.
|
|
|
|
The AVR programming code is at B690.
|
|
|
|
Before you begin programming the chip, the device must be desel-
|
|
ected. Ensure with "0 (spie)".
|
|
|
|
Then, you initiate programming mode with "asp$", and then issue
|
|
your commands.
|
|
|
|
Each command will verify that it's in sync, that is, that its
|
|
3rd exchange echoes the byte that was sent in the 2nd exchange.
|
|
If it doesn't, the command aborts with "AVR err".
|
|
|
|
# Access fuses
|
|
|
|
You get/set they values with "aspfx@/aspfx!", x being one of "l"
|
|
(low fuse), "h" (high fuse), "e" (extended fuse).
|
|
|
|
# Access flash
|
|
|
|
Writing to AVR's flash is done in batch mode, page by page. To
|
|
this end, the chip has a buffer which is writable byte-by-byte.
|
|
|
|
Writing to the flash begins with a call to asperase, which
|
|
erases the whole chip. It seems possible to erase flash page-by-
|
|
page through parallel programming, but the SPI protocol doesn't
|
|
expose it, we have to erase the whole chip. Then, you write to
|
|
the buffer using aspfb! and then write to a page using aspfp!.
|
|
Example to write 0x1234 to the first byte of the first page:
|
|
|
|
asperase 0x1234 0 aspfb! 0 aspfp!
|
|
|
|
Please note that aspfb! deals with *words*, not bytes. If, for
|
|
example, you want to hook it to A!*, make sure you use AMOVEW
|
|
instead of AMOVE. You will need to create a wrapper word around
|
|
aspfb! that divides dst addr by 2 because AMOVEW use byte-based
|
|
addresses but aspfb! uses word-based ones. You also have to make
|
|
sure that A@* points to @ (or another word-based fetcher)
|
|
instead of its default value of C@.
|